@dangowrt
https://forum.openwrt.org/t/saving-changes-on-mount-point-page-causes-device-to-fail/206368
I posted on a forum a few years ago but didn't get an answer. This issue seems to occur only on ext4 systems. The problem occurs when I change any options in system -> mount points and save&apply.
Looking at "ubus monitor," it seems to be attempting to remove the system partition using mount.remove and then remount it to /mnt. Is that correct? I am not a developer, so I may not be entirely accurate. I would appreciate it if you could take a look.
ubus monitor.txt
@dangowrt
https://forum.openwrt.org/t/saving-changes-on-mount-point-page-causes-device-to-fail/206368
I posted on a forum a few years ago but didn't get an answer. This issue seems to occur only on ext4 systems. The problem occurs when I change any options in system -> mount points and save&apply.
Looking at "ubus monitor," it seems to be attempting to remove the system partition using mount.remove and then remount it to /mnt. Is that correct? I am not a developer, so I may not be entirely accurate. I would appreciate it if you could take a look.
ubus monitor.txt